GE RGB740 Owner's Manual & Installation Instructions page 44

,0
,0
,0
,0
iiiii{!!!iii_i!iiiiiiiiiiiii
iiiiHl! iiiii
m
Before you call for service...
Troubleshooting tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Topburners do not light
or do not bum evenly
Possible Causes What To Do
Plug on rmlge is not completely
inserted in the electrical outlet.
Burner hole or slits on the side
of the burner may be clogged.
• Make sure electrical plug is plugged into a live, properly
grounded outlet.
• ]_.elnove tile bm'ne_ (on models with standard twin
bm'ne_) or bm'ner heads and caps (on models with
sealed bm'ne_) and clean them with a sewing needle
or twist-fie. Make sure you do not enlarge tile holes.
On sealed burner models, check and clean tile electrode
area for
b/u'iled-oll
t0od
or grease.
hnproper burner assembly. • Make sure the burner parts m'e installed correctly.
See the Care and cleaning of the range section.
Burnerflames very hnproper air to gas ratio. • If r;mge is
connected
to l,P gas, contact the l/e_sou
large oryellow
who installed your rm_ge or made tile couve_iou.
Surface burners light
but oven does not
The oven gas shut-off valve
may have accidentally been
moved during clemfing or
movhlg.
• To check tile oven gas shut-off valve on sealed burner
models, remove tile storage drawer
or kick panel
(see
tile Care and cleaning of the range section) and look fin.
tile gas shut-_)fl lever at tile back of tile range.
Lover is
shownclosed.
PULL TOOPEN.
Sealed burner models
• To check tile oven gas shut-off valve on standard twin
bm'ner models, raise tile cooktop and look fin" tile gas
sh ut-off lever at tile extreme right rear corne_: Follow
tile directions in box
A or B
that match yore" regulator
_])e.
Lever is shownclosed. A
POLk TOO, P EN._
,[,l \
Standardtwin burnermodels Standardtwin burnermodels
Control signals alter
You forgot to enter a bake • Touch the
BAKE
pad m_d desired temperattu'e or
entering cooking time
or temperature or clemahlg time.
the SELFCLEAN
l/ad :rod desired clean time.
start time ton some models,
Clockandtimer Plug
on rallge is not completely • Make Stll'e electrical l/lug, is l/lugged,, lute a live,
do not work
inserted in the electrical outlet, properly grotmded outlet.
(on some models)
A fuse ha your home may be
• Replace
the fl/se or reset the circuit breakel:
blown or the circuit breaker
tripped.
Oven controls improperly set.
• See the Using the clock and timer
section.
44