Care And Cleaning; Burner Assemblies - GE JGBS04 Owner's Manual & Installation Instructions

Non-self-cleaning gas ranges
Table of Contents

Advertisement

£o
o
u
P
v
i
8
Care and cleaning of the range.
i
m
m m
Be sure electrical power is off and all surfaces are coot before cleaning ang part of the range.
Ifgour range is removed for cleaning, servicing or ang reason, be sure the anti-tip
device is reengaged properfg when the range is replaced. Failure to take this precaution
could result in tipping of the range and cause injury.
.....
Standard
Twin Burner
Assemblies
fansome models)
CAUTION:
Be not operate the ceektop without all
burnerparts,drip pans(if soequipped)
andgratesin place,
For cleaning information on sealed
burners, see next section. Sealed burner
cooktops do not lift up.
Ij
To remove burned-on food, soak the surface
burner in a solution of mild liquid detergent
and hot water.Soakthe surface burner for
20-30 minutes.
:--:_: On models with standard twin burners, the '
Turn all controls OFF before removing burner
parts and drip pans (ifso equipped).
Theburner grates and drip pans (ifso
equipped) can be lifted off, making them
easg tO clean.
The holesin the surface burnersof gour
range must be kept clean at all times for
proper ignition and an even, unhampered
flame.
Youshould clean the surface burners
routinelg,especiallg after bad spillovers,
which could clog these holes.
Wipe off surface burners.If heavg spilIover
occurs,remove the surface burnersfrom the
range.Burnerslift out fordeaning. Lift upthe
cooktop and then lift out the surface burners.
Clean these holes thoroughly on each
burner•
• Drip Pans/ifso
equipped)
Removethe grates and lift out the drip pans.
Drippans can be cleanedin a dishwasheror
:?i:":_:L_•_:,:.:.:.:.:?:::_•_:::,-:..-_::._
.... : :_"•_ bg hand.
When replacingthe drip pans, make sure
theg are in the correct position.
For more stubborn stains, use a cleanser like
Soft Scrub ®brand or Ban AmP brand. Rinse
.well to remove ang traces of the cleanser
that might clog the surface burner openings.
Do not use steel wool because it willclog
the surface burner openings and scratch the
surface burners. Ifthe holes become clogged,
clean them with a sewing needle or twist4ie.
Beforeputting the surface burner back,shake
out excesswater and then drg it thoroughlg
bg setting it in a warm oven for 30 minutes.
Then placeit backin the range, making sure
it is propedg seated and level.
Checkthe flame pattern of each burner.If
the flames are '_iumpg"inot steadg),cleanthe
holesagain with a sewing needle or twist-tie.
To get rid of burned-on food, placethem
in a covered container (or plastic bag)
with _/4 cup ammonia to loosenthe soil.
Thenscrub with a soap-filled scouring
pad if necessarg.
CAUTION: no not clean
the drip pans in a self-cleaningoven.
2O

Advertisement

Table of Contents
loading

Table of Contents