Clock And Timer - GE CGS980 Owner's Manual & Installation Instructions

Self-cleaning
Table of Contents

Advertisement

Using the clockand timer.
GEAppliances.com
Not all features are on all models.
Make sure the clock is set to the correct
time of day.
To Set the Clock
The clock must be set to the correct time of
day for the automatic oven timing functions
to work properly. The time of day cannot be
changed during a timed baking or self-
cleaning cycle.
i-71 Touch the CLOCK pad to set.
[]
Touch the number pads.
Touch the number pads the same way you
read them. Forexample, to set 12:54,touch
the number pads 1, 2, 3 and 4 in that order.
If number pads are not touched within one
minute after you touch the CLOCK pad, the
display reverts to the original setting. If this
happens, touch the CLOCKpad and reenter
the time of day.
r-_ Touch the STARTpad until the time
of day shows in the display.This
enters the time and starts the clock.
To check the time of day when the display
is showing other information, simply touch
the CLOCKpad. The time of day shows until
another pad is touched.
®®®®®
®®®®®
The timer is a minute timer only.
The C/.EAR/OFFpaddoesnot affect
the timer.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
[Z]
Touch the KITCHEN TIMER ON/OFF pad.
Touch the number pads until the
amount of time you want shows in the
display. The maximum time that can be
entered in minutes is 59.Times more
than 59 minutes should be changed to
hours and minutes. For example, to
enter 90 minutes as 1 hour 50 minutes,
touch 1,3 and 0 in that order.
Ifyou make a mistake, press the KITCHEN
TIMER ON/OFF pad and begin again.
%
Touch the STARTpad. After pressing
the STARTpad, SETdisappears; this tells
you the time is counting down, although
the display does not change until one
minute has passed.
[]
When the timer reaches :00othe control
will beep 3 times followed by one beep
every 6 seconds until the KITCHEN
TIMERON/OFF pad is touched.
The 6 second tone can be canceled by
following the steps in the Special features
of your oven control section under Tones
at the End of a Timed Cycle.
t_
e,,i.
MiiiiiiiiiJiiiiiii
iiiiii_ii_iiiijiii_iii
i/ii_iiiiiii_iiiiiiiiiiii_ii
iii_iiii!ii,,_iiiiiiiiii!
r
U
_
P
v
to
0
0
e,,i.
.
0
to
0
15

Advertisement

Table of Contents
loading

Table of Contents