Latch-Lock Lever - GE JBP29G Use And Care & Installation Manual

Hide thumbs Also See for JBP29G:
Table of Contents

Advertisement

Care and Clearfing
Operating the Self-Clearfing Oven
(continued)
3. Slide the door LATCH HANDLE
to the left as far as it will go_
Set the Oven for Cleaning
The range must be completely
cool
in order to set the self-clean
cycle
1. Slide the LATCH HANDLE
to
the right as far as it wil! goo You
may need to slightly press on the
door to get it to lock properly
Never force the door latch handle.
Forcing
the handle may damage
the door lock mechanism.
2, Push the CLEAN
button.
The display will show "3:30"
The words "CLEAN
TIME"
will
be displayed on the left. Within 20
seconds, the words "CLEAN
LOCK"
wil! be displayed
on the
rightr
Note: You can find out when the
clean cycle will be finished by
pushing the STOP TIME button..
The word "DOOR"
is displayed
when you try to set a clean cycle
with the door unlatched
or when
the oven temperature
is too high.
To Set a Delayed Start
1. Slide the LATCH HANDLE
to
the right as far as it will go.
2. Push STOP TIME button,
3. Turn SET knob to time of' day
when you wish cleaning
to he
completed
(must be more than
3 Vz hour's later than current time
of day).
4. Push the CLEAN
button°
The words "DELAY
CLEAN"
will be on in the display until the
clean cycle starts, After the clean
cycle starts, the word "CLEAN"
will be on in the display,_
Note: During a delayed self-clean
operation
you can find out when
the oven turns on by pushing and
holding the CLEAN button.
To Stop a Clean Cycle
1. Press the CANCEL button,
2, Wait until the oven has cooled
below locking temperature
(about
20-30 minutes) and the word
"LOCK"
is off in the display.
You will not be able to open the
door right away unless the oven
temperature
is at a safe level. If
you cannot open the oven door
immediately after the word "LOCK"
goes off, wait one minute and try
again.
After Self-Cleaning
1, When a clean cycle is finished,
the woifl "CLEAN"
will be off in
the display.
2, Wait until the oven has cooled
below locking temperature
(about
20-30 minutes)
and the word
"LOCK"
is offin the display.
3, Slide the door LATCH HANDLE
to the left as far as it will go
You will not be able to open the
door unless the oven temperature
is at a safe level,, If you cannot open
the oven door immediately
after the
word "LOCK"
goes off, wait about
one minute and try again.
You may notice some white ash
in the oven. Just wipe it up with
a damp cloth,
If white spots remain,
remove them
with a soap-filled
steel wool pad.
Be sure to rinse thoroughly
with a
vinegar and water mixture,
These
deposits
are usually a salt residue
that can not be removed by the
clean cycle°
If the oven is not clean after one
clean cycle, repeat the cycle
26

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jb553gJb570gJb571g

Table of Contents