GE J2B912 Installation And Owner's Instructions page 48

,0
,0
&,
,0
,0
iiiii{!!!iii_i!iiiiiiiiii)i
iiiiHl! iiiii
m
rd)'_
Before you call for service...
Troubleshooting -tips
Save time and money! Review the charts on the following
pages first and you may not need to call for service.
Possible Causes
Plug on rm_ge is not completely
inserted in the electrical outlet.
Burner slits on the side of the
burner may be clogged.
What To Do
Make sure elect_-ical I)lu(*-, i s I)lugged,, into a lixe, properl)
grounded outlet.
Topburners do not light
or do not burn evenly.
(The front right burner is * Remove the burne_ and clean them. Check the
designedto have slightly
electrode
area h)r bu/'ned-on
h)od ()r grease. See
smaller flames between the Care and cleaning of the range section.
the 6 and 9 o'clock
positions. This is normaL) Improper burner assembly. * Make sure the burner parts are installed c(>rrecth'.
See the Care and cleaning of the range section.
Burner flames very Improper air to gas ratio. • It _'ange is connected to l.P gas, contact the pe_'son
large or yellow
who installed veto" ran,*e or made the conversion.
Surface burners
light
The oven gas shut-off valve * To check the oven gas shut-oil valve, remove the
but oven does not may have accidentally been wamfing dl'awer (see the Care and cleaning of the range
moved during clemfing or section), l.ook for the gas shut-oft lever at the back of
moving, the ran *e
Lever is
shownclosed.
PULL TOOPEN.
48