GE J2B912 Installation And Owner's Instructions page 46

Installation instructions
[] ADJUST OVEN BURNER AIR
ADJUSTMENT SHUTTER IF
NECESSARY
Air adjustment shutter for the bottom burner regulates
the flow of air to the flames.
Loosen
\
Jstment
shutter
The shutter _Or the bottom (oxen) burner is near the
back wall behind the warming drawer. ]_elnoxe the
drawer. See the Care and cleaning of the range section.
To adjust the flow of air to the burner, loosen the
Phillips head screw and rotate the shutter toward open
or closed position as needed.
To determine if the bottom burner flames are bm'ning
properly; remove the oven bottom. Flames should have
al)l)roximately 1" blue cones and, if range is SUl)plied
with natural gas, should burn with no yellow tipping.
(With most I.P gas, small yellow tips at the elm of outer
cones are imrmal.) Flalnes should not lilt off burner
ports. If lilting is observed, gradually reduce air shutter
oi)ening until flalnes are stabilized.
To remove the oven bottom:
A. ]_elnove the two screws securing the bake element
to the back of the oven and remove the element.
B. Remove the screws holding down rear of the
oven bottom.
C. (_i'asi) the oven bottom at finger slots on each side.
Oven bottom
D. I.ili the rear of the oxen bottoln enouoh to clear the
lip of the range fralne, push it back, and then pull it
tip and ()tit.
[] LEVELING THE RANGE
A. Install the oxen shelxes in the oxen aim position the
range where it will be installed.
Raise Lower
II Lower range range
range
range
(on some models) (on some models)
B. Check fin" levelness by placing a spirit level or a cup,
partially flled with water, on one of the oven shelves.
If using a spirit level, take two readings--with the
level placed diagonally first in one direction and
then the other.
C.
n.
Remove the drawer. See the Care and cleaning of the
range section. The front leveling legs can be ac!justed
fl'oln the bottoln and the rear legs can be a(!justed
fl'Oln the top or the bottom.
Use an open-end or a(!justable wrench to a(!just the
lexeling legs tmtil the range is lexel.
E. After the range is lexel, slide the range awa} from the
wall so that the Anti-Tip dexice can be installed.
46