GE J2B912 Installation And Owner's Instructions page 36

Installation
Instructions
Range
In the Commonwealth
of Massachusetts
• This product must be installed by a licensed
phunber or gas fitter,
• When using ball Wpe gas shut-off valves, they shall
be the T-handle type.
• A flexible gas connectm; when used, must not
exceed 3 fl_et.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
Installation of this range must conform with local
codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1/NFPA.54,
latest edition. In Canada, installation must conform
with tim current Natural Gas Installation Code,
CAN/CGA-B149,1 or the current Propane Installation
Code, CAN/CGA-B149.2, and with local codes where
applicable. This range has been design-certified hy
CSA International according to ANSI Z21.1, latest
edition and Canadian Gas Association according
to CAN/CGA-I.1 latest edition,
As with any appliance using gas and generating beat,
there are cel_ain saibty precautions you should tollow.
You will find these precautions
in the Important Safety
Information section
in the fi'ont of this manual. Read
them carefully.
• IMPORTANT - Save hese
instructions fin" local electrical inspector's use.
• IMPORTANT - Observe all
governing codes and ordinances.
• Note to Installer
- I,eave these instructions
with the appliance alter installation is completed.
• Note to Consumer
- Kee I) this Owner's
Manual and Installation Instructions fin" future
re_erence.
•
Note
- This appliance must be properly grotmded,
•
Servicer
- The electrical diagram is in an emvlope
attached to the back of the r;mge.
• SMll level - Installation of this appliance requires
basic mechanical skills.
• Proper installation is the responsibility of the
installe_:
• Product thilure due to improper installation is not
covered under the _'_.u'lanty.
FOR YOUR SAFETY
Do uot store or use combustible materials, gasoline or
other flammable vapors m_d liquids in the vicinity of
this or any other appliance.
If you smell gas:
O Open windows.
O Don't touch electrical switches.
Extinguish any open flame.
O hmnediately call yore" gas supplier.
TOOLS YOU WILL NEED
Phillipsscrewdriver
Flat-bladescrewdriver Open-endor
adjustablewrench
Penciland ruler
Level
Pipewrenches(2)
(one for backup) Drill, awl or nail
MATERIALS YOU MAY NEED
• (;as line sh m-off valve
• Pipe joint sealant
or UI:approved
pipe thread tape
with Teflon':: that resists action el natural and I,P gases
• Fle_ble metal appliance connector (1/9" I.D.)
A 5-tOot length is recommended fin" ease of installation
btlt
other lengths are acceptable. Never rise an old
connector when installing a new range.
• Flare ration adapter
for connection
to gas supply line
(3/4" or 1/2" NPT x 1/2" I.D.)
• Flare ration adapter for connection to pressm'e
regulator on range (1/2" NPT x 1/2" I.D.)
• iJquid leak detector or soapy water:
• i_ag bolt or l/9" O,D, sleeve anchor (fin" concrete
floo_ only),
*Teflon: Registered tn,demal-k of DuPont
36