GE J2B912 Installation And Owner's Instructions page 30

Cam and cleaning of the range.
Bumerheads
i
Burner Caps and Heads
Before remov/bg the burner caps and heads,
remember thek m2e and location. Replace them/#
the same location afier c/eaning.
NOTE: Do not use steel wool or scouring powders
to clean the burner parts.
Burner caps
i,ifl off when cool. _Aash burner caps in hot,
soap) water and rinse with clean water: Ym
may scorn" with a plastic scoming, i)ad to
remoxe bm'ned-on fi)od particles.
Burner Heads and Oval (Center) Burner
Head/Cap Assembly
The burnerheads and theovalburner head/cap
assembly are removable. Simply lift them off the
range for clean/#g.
For proper ignition, make sm'e tile
small hole in the section that fits oxer the
electrode is kept open. A sewing needle
or wire twist-fie works well to tmch)g it.
The silts in the burner heads must be kept dean
at all times for an even, unhampered flame.
The burner heads are removabte.
Simply liRthem Offthe rang e for (}logged or (lir_
bt/Fner
ports or
cleaning, electrodes will not allow tile bt/Fnei" to
operate properly.
Any spill on or arotmd an electrode must
be carefifll) cleaned. Take care to not hit an
electrode with anything hard or it could be
da In a oed
(:lean the bm'ner heads routinely, especiall_
after bad spillove_s, which could clog the
openings. I,ifl off when cool.
To remove bm'ned-on fi)o(l, soak tile
bm'ner heads in a solution of mild liquid
detergent and hot water fi)r 20-30 minutes.
For more stubborn stains, use a toothbrush.
_'_-J2X Holein
___7_ burner
The ova! burner head/cap assembly is
removable. Simpty lift it off the range
for cleaning, Use a sewing needle or
twist-tie to unclog the small hole in
the burner heads.
After cleaning
Befi)re putting tile bm'ner caps, heads
and
o\al head/cap asselnbly back, shake out
excess water aim then di T theln thoroughly
by setting in a warm oven fin" 30 milmtes.
Replacement
Burner Heads
Replace bm'ner heads over tile electrodes
on the cooktop, in tile correct locations
according to their size. There is one small,
one medium, one large and one extra lmge
burner head.
rent of rang
Make sure the slot in the burner head is
p()siti(med over the electlx Me.
Eleetrode_
Oval (Center) Burner Head/Cap Assembly
Replace the oxal (center) head/cap
assembly over the electrode on the cooktop.
Ova!headand cap Make surethe slot in the
assembly burner head is positioned
overthe electrode.
)
* ®
Frontof range Electrode
Caps
Replace tile matching size caps onto the
burner bases or heads.
iVle ap I .... I Sr na,
Frontof range
Make sm'e that tile heads
and caps
are
replaced in tile correct h)cafions.
30