GE J2B912 Installation And Owner's Instructions page 12

Usingthe oven.
Toavoid possible bums, place
Theovenhas 5shelf positions.
It alsohasa speciallow shelf
position(R)for extralarge items,
such asa large turkey.
the shelves in the desired position before you turn the oven on.
Before you begin...
The shelves have stop-locks, so that when
placed correctly
on the shelf sui,_ports (A
through E), the_ will StOl) before confing
completely out, and will not tilt.
_,\qmn placing and remo_in-_ cookware,
pull the shelf out to the bum I) on the shelf
suI)port.
To remove a sheff, pull it toward you, flit the
fl'ont end up and pull it out.
To replace, place the end of the shelf (stoi>
locks) on the suI)port, tilt up the ti'ont and
push the shelf in.
NOTE: Theshelf is not dest)ned to slide out at the
specta/low shelf (R)position.
Plastic items on flTecooktop may
melt if left too close to the vent.
Vent appearance and location varg
Oven Vent
Your oven is vented through ducts at the
rear of the range. Do not block these ducts
when cooking in the oven--it is important
that the flow (ff hot air ti'om the oven and
ti'esh air to the oven btlYner be
tminterrul)ted. Avoid touching the vent
openings or nearby Stllb{ilces dining oven or
broiler operation--they may become hot.
!i>Handles of potsandpanson thecooktop may
become hot if left toodose to thevent
!i>Do not leave plastic or flammable items on the
cooktop--they may melt or ignite if left too close
to the vent.
iJi:: D o not leave closed containers on the cooktop.
Thepressure in dosed contalbers may lbcrease,
which may causethem to burst.
iJi:: Metal itemswill become very hot if theyareleft
on thecooktop, a ndcouldcause bums.
Power Outage
CAUTION: D onotmakeanyattemptto operate the
electricignitionovendunngan electrical power
failure.
The oven or broiler cmmot be lit dtwino a
power fifilm'e, (;as will not flow mfless the
glow bar is hot.
If the oven is in use when a power fifilm'e
occm_, the oven burner shuts off and
cmmot be re-lit tmtil power is restored, This
is because the flow of gas is automatically
stopped and will not resume when power is
restored tmtil the glow bar has reached
operating temperature.
Oven Light
Touch the OVEN LIGHTpad on the control
panel to mrn the light on or off.
12