Anti-Tip Bracket; Leveling - GE JBP60 Owner's Manual

iiiiiiiiiii iii!iili iilii,!i
iiiiiiii ii/
Installationof therange.
Read these instructions completely and carefully.
[] Anti-tip Bracket Installation
An Anti-tp bracket is supplied with instructions tbr installation in a varie h-
ot locations. The instructions include a template, a parts list and a list of tools
necessm)" to complete the installation. Read the bnportant Safety information
and the instructions that fit your situation betore beginning installation.
WARNING
Range nmst be secured b? Anti-tip bracket supplied.
_ See instructions to install (supplied with bracket).
Unless properly installed, tile range could be tipped by stepping or sitting on
the door. lnjux), might resuh ti'om spilled hot liquids or ti'om the range itselt'.
Typica/ installationof anti-tipbracketaitachmentto wa//.
[] Leveling the Range
Tile range nmst be level. 1Jeveling feet are located at each corrzer of tile base ot
tile range. Remove tile storage drawer or kick panel (depending on your model)
and using channel locks, rotate the leveling teet in and out as required to level
tile range. (l_or instructior_s on how to remove and replace tile storage drawer or
the kick panel, see the Care and cleaning of the range section.)
On some models, there are plastic covers which may be removed h)r easy
a(!iustment (just squeeze and pull).
( )ne..... ot the rear leveling, teet will enga, g,e the Anti-rip bracket (allow tor some side
to side a(!iustment). Allow a minimum clearance ot 1/8"l)etween the range and
the leveling toot that is to be installed into the Anti-tp bracket
Check the range tor proper installation into the Anti-rip bracket by removing the
kick panel or storage drawer and inspecting the rear leveling leg. Make sure it tits
se(alrely into the slot.
[] Final Check
Be sure a# range controls are in the OFF position before leaving the range.