Receiver And Remote Control Programming - Craftsman 139.53800SRT Owner's Manual

Receive and Remote ControR Programming
To cornply v;ilh FCC rules, ad{uS{meni or modi_oa{ions Of i_
andior transmitter are prohibited, except for changing the code setting or 1
replacing the batlery THERE ARE NO OTHER USER SERVICEABLE I
PARTS J
Models with 3-function remote controls: The
remote controls have been factory set to operate
with the large push button on the remote control.
However, you can use either of the two small
buttons, if you prefer. And, the 3-function remote
control can also activate additional garage door
openers and/or light controls..
Below are instructions for programming your opener
to match the other buttons on your remote controls
and any additional remote controls you may
purchase. See available accessories on page 38_.
Children operating or playing with a garage
door opener can injure themselves or others,
The garage door could close and cause
serious injury or death. Do not allow children
to operate the door push button(s) or remote
control(s).
A moving garage door could injure or kill
someone under it. Activate the opener only
when you can see the door clearly, it is free of
obstructions, and is properly adjusted.
53000SRT Series Garage Door Openers
(With "SRT" Button)
Your "SRT" garage door opener will operate with as
many as four "SRT" portable remote controls and
one Multi-Function Key]ess Entry,
To Add A Remote Control
1, Press and holdthe seiected remote control push
button, see Figure 1..
2..Then press and release the "SRT" button on the
right side panel of the opener, Figure 2. The
opener lights will flash once..
3. Release the remote push button.
Now the opener will operate when the remote
control push button is pressed.
If you release the remote control push button
before the opener lights flash, the opener will
not accept the code.
To Change the Selected Push Button
On the Same Remote control
If you decide to use a different remote control button
than originally programmed into the opener, you
must erase all the learned codes and reprogram
each remote control used to operate the garage
door opener..
To Erase All Remote control Codes
- Press and hold the "8RT" button on the opener
panel until the indicator light turns off (about 6
seconds). A//the codes the opener has learned
will be erased.
=To reprogram, repeat Steps 1,2 and 3 for each
remote control in use..
Code programming instructions are also located
on the opener panel.
Figure I
Figure 2
Select a remole control push
button !o operate opener
3-Function
Remote Control
Garage Door Opener
(With "SRT" Button)
© ©
k
"SRT" Indicator
Butlon Ugh!
END PANEL
33