Fasten Door Bracket (One-Piece Door) - Craftsman 139.53800SRT Owner's Manual

Please read and compty with the warnings and reinforcement nnstructions on page 24.
They apply to one-piece doors also.
I
Header
Bracket
2x4 Suppo_
Bracket
Vertical
Garage Door
Horizontal and verlical
reinforcement is needed for
[{ghtwetght garage doors
(fiberglass, aluminum, steel,
door with glass panel, etc,)
Door
Bracket .,._ Top of Door
(inside Garage)
of Doer
PJacement j
!
ora doorwIth no n : /
exposed framing or for H , , /
{ " Carnage Bolt
use 5116"x1-1_" lag ,_ ='=" ...... _"
screw (not supplied) to _,' ../
fasten door bracket, _ _J'_
, Center the bracket on the top of the door, in line
with the header bracket as shown° Mark holes°
° Drill 5/16" pilot holes and fasten the door bracket
with hardware supplied.
If the door has no exposed framing, drill 3/16" pilot
holes and fasten the bracket with 5/16"x1-1/2" lag
screws (not supplied) to the top of the door°
The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dotted line optional placement
drawing.) Drill 3116" pilot holes and substitute
5/16"x1-1/2" lag screws (not supplied)to fasten
the bracket to the door.
Hardware Shown Actual Size
© ©
Nut 5/16"-18 Lock Washer 5116_
25