Table of Contents
Advertisement
Read the Safety instructions
on page 12. They also apply to doors without tracks.
- Close the door and mark the
H Ill
inside vertical centerline of
fl
I;_
your garage door. Extend the
l!
I{
line onto the header wall
I[ 1t
above door.
I1H
If headroom clearance is
1! [_"
minimal, you can install the
H I_
header bracket on the ceiling,
tl
]H/
See page 14.
11 II_'
• If you need to install the
]! I11
header bracket on a 2x4 (on
II
I_
wall or ceiling), use lag screws
]1 IN
(not supplied) to securely
H I_
fasten the 2x4 to structural
t]
supports as shown_
I] _It
_JuL
Header Wail
__Verlical
enter,line
2x4
fl
lli Conte_Ineef llr
!
OPTIONAL
CEILING MOUNT
FOR HEADER
BRACKET
Doer
I
Jamb
Ha_ware
Header Wall
Highest Point
of Travel
iT
One-piece door without track
jamb hardware
Header
HighestPoint
of Travel
',10
o
One-piece door without track
pivot hardware
• Open your door to the highest point of travel as
shown. Measure the distance from the top of the
door to the floor, Subtract the actual height of the
door, Add 8" to the remainder. (See Example).
- Close the door and draw an intersecting horizontal
line on the header wall at the determined height.
If the total number of inches exceeds the height
available in your garage, use the maximum
height possible, or refer to page 14 for ceiling
installation.
EXAMPLE
Distance from top of door
(at highest point of travel) to floor ........................... 92"
Actual height of door .............................................
-88"
Remainder ..................................................................
4"
Add .........................................................................
+8"
Bracket height on header wall ...............................
12"
(Measure UP from top of CLOSED door.)
Proceed
to Step 2, page 14.
13
Hide quick links:
Advertisement
Table of Contents
