Advertisement
Storage drawer
is crooked
GEAppliances.com
Possible
Causes
Rear drawer support
is
on top of the guide rail.
What To Do
• Reposition the drawer. See the Storage Drawer
Remova! instructions in the Care and cleaning
of the range section.
Storage drawer
won't close
Power cord mag be
obstructing
drawer
in the lower back
of the range.
• Repositionthe drawer and power cord. Seethe
Storage Drawer Removal instructions in the Careand
cleaning of the range section.
Rear drawer support
is
on top of the guide rail.
• Reposition the drawer. See the Storage Drawer
Removal instructions in the Care and cleaning of the
range section.
=
Oven will not self-clean
The oven temperature
is
• Allowthe oven to cool to room temperature
and
too high to set a self-clean
reset the controls.
operation.
Oven controls impropedg
set.
• See the Using the self-cleaning oven section.
Oven door is not in the locked
• Hake sure Sou move the door latch handle all the
position,
wag to the right.
"Crackling" or
This is the sound of the
• This is normal.
"popping" sound
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking
Excessive soil.
• Touch the Clear/Off pad. Open the windows to
during a clean cgcle
rid the room of smoke. Wait until the light on the
Self Clean pad goes off. Wipe up the excess soil and
reset the clean cycle.
Oven door will not
Oven too hot.
• Allow the oven to cool below locking temperature.
unlock
Oven not clean after
Oven controlsnot properlg set. • Seethe Using the self-cleaning oven section.
a clean cgcle
Oven was heavilg soiled.
• Clean up heavg spillovers before starting the clean
cgcle. Heavilg soiled ovens mag need to self-clean
again or for a longer period of time.
"F-" and a number
You have a function
• Disconnect all power to the range for at least
or letter flash
error code.
50 seconds and then reconnect power. If the function
in the display
error code repeats, call for service.
• On self-cleaning models, if a function error code
appears during the self-cleaning cgcle, check the oven
door latch. The latch mag have been moved, if onlg
slightlg, from the locked position. Hake sure the latch
is moved to the right as far as it will go. Touch the
Clear!Off pad. Allow the oven to cool for one hour.
Putthe oven back into operation.
Water remaining on
This is normal.
oven floor after Steam
Clean cycle
• Remove ang remaining water with a drg cloth
or sponge.
55
Advertisement
