Advertisement
Cleaningthe glass cooktop, ran s ome mode/s
Clean yourcooktopafter
each spill. Use CERAMA
BRYTE ® Ceramic Cooktop
Cleaner.
Normal
Dailg
Use Cleaning
ONLY useCERAMABRYTE ® Ceramic
Cooktop Cleaneron the glass cooktop.
Other creams nag not be as effective.
To maintain and protect the surface of
gour glass cooktop, follow these steps:
Before using the cooktop for the
first time, clean it with CERAMA
BRYTE ® Ceramic Cooktop Cleaner.
This helps protect the top and makes
cleanup easier.
[_
Dailg use of CERAMA BRYTE ®Ceramic
Cooktop Cleaner will help keep the
cooktop looking new.
%
Shakethecleaning cream well.
Applg a few drops ofCERAMA BRYTE ®
CeramicCooktop Cleaner d irectlg
tothecooktop.
Use a paper towel or CERAMA
BRYTE ® Cleaning Pad for Ceramic
Cooktops to clean the entire cooktop
surface.
[]
Use a drg cloth or paper towel
to remove all cleaning residue.
No need to rinse.
NOTE: It is very important that you DO
NOT heat the cooktop unti! it has been
cleaned thoroughly.
Usea CERAMA BRYTE ® CleaningPadfor
CeramicCool<tops.
Burned-On
Residue
NOTE: DAMAGEto Four glass surface
may occur if you use scrub pads other
than those recommended.
I-f]
Allow the cooktop to cool.
[]
Spread a few drops of CERAMA
BRYTE ®Ceramic Cooktop Cleaner
on the entire burned residue area.
%
Using the included CERAMABRYTE ¢
Cleaning Padfor Ceramic Cooktops,
rub the residue area, applging
pressure as needed.
[]
%
If ang residue remains, repeat
the steps listed above as needed.
For additional protection, after all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ®Ceramic Cooktop Cleaner
and a paper towel.
TheCERAMA BRYTE ® CeramicCool<top
Scraperand all recommended supplies
are availablethrough our PartsCenter.
Seeinstructionsunder"To OrderParts"
section on next page.
NOTE:Do not use a dull or
nicked blade.
Heavg,
Burned-On
Residue
[]
Allow the cooktop to cool.
Use a single-edge razor blade
scraper at approximatelg a 45 °
angle against the glass surface and
scrape the soil. It will be necessarg
to applg pressure to the razor
scraper in order to remove the
residue.
%
After scraping with the razor
scraper, spread a few drops of
CERAMA BRYTE ®Ceramic Cooktop
Cleaneron the entire burned residue
area. Use the CERAMABRYTE ®
Cleaning Pad to remove any
remaining residue.
[]
For additional protection, offer all
residue has been removed, polish
the entire surface with CERAMA
BRYTE ® Ceramic Cooktop Cleaner
and a paper towel.
30
Advertisement
