Advertisement
GEAppliances.com
j
j SHOCK OR BURN HAZARD: Before
replacing
oven light bulb, disconnect
WARNING j the electrical
power tothe range atthe main f use o rcircuit breaker
panel
Failure to do so mag result in electric shock or burn.
i
J BURN HAZARD: The glass cover and bulb should be removed when cool.
-&CAUTION
Touching
hot g lass with b are h ands oradamp cloth c an cause burns
Becee_acle
Socket
/
C ass Cover
(onsomemodels)
Receptacle
Socket
i
i
k
Oven Light Replacement
ton some models)
To remove:
F11 Turn the glass cover counterclockwise
1//4turn until the tabs of the glass
cover clear the grooves of the socket.
Wearing latex gloves may offer
a better grip.
[_
Using gloves or a drg cloth, remove
the bulb by pulling it straight out.
To replace:
[77 Use a new 120/150-volt halogen bulb,
not to exceed 50 watts. Replacethe
bulb with the same type of bulb that
was removed.Your model will have
one of the two types shown on
the left. To determine the correct
replacement bulb, check the bulb
terminals. Bulbs with 2 straight pin
terminals are G6.55 bulbs. Bulbs
with 2 looped terminals are G9 bulbs.
(Donot interchungeJ Be sure the
replacement bulb is rated 120 volts
or 150 volts (NOT12 volts).
_q
Using gloves or a drg cloth, remove
the bulb from its packaging. Do not
touch the bulb with bare fingers. Oil
from skin will damage the bulb and
shorten its life.
Pushthe bulb straight into the
receptacle all the wag.
[_
Placethe tabs of the glass cover into
the grooves of the socket. Turn the
glass cover clockwise 1/4 turn.
For improved lighting insidethe oven,
clean the glass cover frequently using
a wet cloth. This should be done when
the oven is completely cool.
[_
Reconnect electrical power to
the oven.
Glasscover
(onsomemodels)
Wire cover holder
Oven Light Replacement
(models equipped with standard 40-watt appliance bulbs)
Be sure to let the light cover and bulb cool
completelg.
To remove the cover:
rT]
Hold a hand under the cover so
it doesn't fall when released.With
fingers of the same hand, firmlg push
back the wire cover holder. Lift off
the cover.
Do not remove ang
Screws
to remove
the cover.
To replace
the cover:
F_
Placeit into groove of the light
receptacle. Pullwire forward to the
center of the cover until it snaps into
place.
[_
Connect electrical power to the range.
[_
Replacebulb with a 40-watt
appliance bulb.
29
Advertisement
