Broiler Pan & Grid; Lift-Off; Shelves - GE EER3001 Owner's Manual

ww_. GEAppliances.com
Oven Shelves
Clean the oven shelves with an abrasive
cleanser or scouring pad. After cleaning,
rinse tile shelves with clean water and dry
with a clean cloth.
NOTE:Take theshelves outof theovenbefore you
begintheself-clean cycleor theymaydiscolor
To make tile shelves slide more easily,
apply a small amount of vegetable oil
to a paper towel and wipe tile edges of
tile oven shelves with tile paper towel.
Do not spray with Pam ®or other
lubricant sprays.
Storage Drawer Removal
Toremovethedrawer.
[] Pull the drawer out until it stops.
[] Lift the front of the drawer until the
stops clear tile guides.
] Remove the drawer.
Toreplacethe drawer:
[] Place tile drawer rails on tile guides.
[] Push the drawer back until it stops.
[] Lif_ the front of the drawer and push
back until the stops clear the guides.
[] Lower the front of the drawer and
push back until it closes.
After broiling remove the broiler
pan from the oven, Do not store a
soiled broiler pan and grid anywhere
in the range.
Broiler Pan & Grid
Donotcleanthebroiler pan orgrid in a self-
cleaning oven.
After broiling, remove the broiler pan
from the oven. Remove the grid from the
pan. Carefully pour out the grease from
the pan into a proper container.
Wash and rinse the broiler pan and grid
in hot water with a soap-filled or plastic
scouring pad.
If fbod has burned on, sprinkle the grid
with detergent while hot and cover with
wet paper towels or a dishcloth. Soaking
the pan will remove burned-on foods.
Both the broiler pan and grid may be
cleaned with a commercial oven cleaner.
Both the broiler pan and grid can also be
cleaned in a dishwasher.
Wire cover holdoK
Oven Light Replacement
CAUTION: Before replacing your oven
light bulb, disconnect the electrical
power to the range at the main fuse or
circuit breaker panel
Be sure to let the light cover and bulb
cool completely.
To remove the cover.
[_] Hold a hand tinder the cover so it
doesn't fall when released. With
tingm.'s of the same hand, firmly
push back the wire cover holder.
Lift off the cover.
Donotremove anyscrews toremove thecover
[] Replace bulb Mth a 40-watt
appliance bulb.
Toreplace the cover.
[] Place it into groove of the light
receptacle. Pull wire fbrward to
the center of the cover until it
snaps into place.
[] Connect electrical power to
the range.
Oven Heating Elements
Donotcleanthebakeelement o r thebroil
elemenL Anysoil will burnoff whenthe
elements areheated.
To clean the oven floor, gently lift
the bake element. Clean with w-arm
soapy water.
23