GE JGBP35 Owner's Manual & Installation Instructions page 46

Before you call for service...
Troubleshooting -tips
Possible Causes What To Do
"LOCK DOOR_' flashes The self-cleaJa cycle has been * Close the oxen door.
in the display selected but the door is not
closed.
LOCKED DOOR light The oven door is locked
is O0 when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
• Touch the CLEAR/OFFpad. _Mlow the oven to cool and
then, on models with a door latch, uuh)ck the dooI:
Oven door willnot Oven is too hot. • _Mlow the oven to cool below locking temperature.
unlock (on models
Do not lock the door with the door latch except when
with a door latch) usiu,, the xelf_cleau feature.
"Door"appears in the Self-clemfing cycle has been • Move tile latch handle :ill tile way tl) tile right.
display (on models selected but the latch handle
with a door latch) was not moved all the way
to the right.
Latch handle was moved to the
• Move the latch hala(lle to tile right only when ,setfiw,
right but a program other than the sell:tie:ruing cycle.
self-clemfing was selected.
"T--and a number or On models with a door latch, • The latch may have been moved, exeu if only slightly,
letter"flash in the display if a function error code appears fi'om the h)cked position. Make st,re the latch ix moved
during the self-clemfing cycle, to tile right as flu" as it will _o
check the oven door latch.
You have a function error code. • Touch the CLEAR/OFFpad. ?dlow the oven to cool for
()lie hl)uI: Put the oveu
back
iuto operatiou.
If the function code repeats. • Dixcl)uue('t ;Ill pi)wer tl) the range for 5 minutes
;ilia thel] l'e('l)lllle('t pl)wel: It the _'Hll('til)l] elTOl"
code repeats, call for service.
Oisplaygoes blank A fuse ha your home may be • Replace the fl,xe or reset tile circuit breaker:
blown or the circuit
breaker tripped.
The clock is ha the • See the Special features of your oven controlsectiou.
black-out mode.
Display flashes
Power failure. • Reset the (lock.
Unable to getthe Oven control pads were • The BAKE mad BROIL HI/LO pads must be touched at
displayto show "SF" not touched properly, tile same time and held fin" 3 seconds.
Power outage, Power outage or surge. • Reset tile clock. If the oven was in use, you must reset
it by touching tile CLEAR/OFFpad, ,settiu,_ tile clock and
resetting :my col)king flmctilm.
Oven shelves are
The nickel shelves (if so equipped)
difficult to slide were clemaed ha a self-clema cycle.
The gray porcelain-coated shelves
(if so equipped) were improperly
clemaed.
• Apply a sxnall axnlmxat i)f vegetable oil to a paper
towel and wipe the edges of the oven shelves with
the paper towel. Di) ul)t spray with Pare _ or other
lubI_iCalat sprays.
46