GE JGBP35 Owner's Manual & Installation Instructions page 36

Installation Instructions
-&WARNING!
ANTI-TIP DEVICE
@
®
All ranges can tip and injury could result.
To prevent accideutaJ tipping of the rmage,
attach an approved AJafi-Tip device to the
wall. (See Installing the Anti-tip Device ha this
section.) To check if the device is hastalled
mad engaged properly, carefully tip the rmage
forward. The Anti-Tip device should engage
mad prevent the rmage from tipping over.
If you pull the rmage out from the wall for
may reason, make sure the Anti-Tip device
is engaged when you push the range hack
against the wall.
• For your safet)', never use your range for waruiing
or heating tile rooni. Your oven and cooktop are
not designed to heat your kitchen.
Top
burners
should not be operated without cookware oil the
grate. Such abuse could result in fire and daniage
to your range and will void your warranty.
• Do not store or use conlbustible ulaterials,
gasoline or other flauunable wq)oi's and liquids
in the vicinity of this or any other ai)pliance.
Explosions or fires could result.
• Do not use ()veil tor a storage area. ]teuls stored in
the ()veil can ignite.
• Do not let cooking grease or other flauinlable
nlaterials accuululate in or near tile range.
LOCATION
Do not locate the range where it may be subject to strong
drafts. Any openings ha the floor or wall behind the rmage
should be sealed. Make sure the openhags aromad the
base of the rmage that supply fresh air for combustion
mad ventilation axe not obs_'ucted by carpeting or
woodwork.
Your range, like ulanv other household iteins, is hea\ T
and can settle into sott floor coverings such as cushioned
vinyl or caipeting. Use care when uloving tile range
on this b'pe (ff flooiing. It is recoumlended that the
following siInple and inexpensive instructions be
fi)llowed to protect your flooI:
Tile range should be installed on a sheet (ff plywood
(or siufilar inaterial). _4]/eIl the floor covering ends at
tile ti'ont of tile range, tile area that tile range will rest
on should be built up with plywood to tile sanle level or
higher than tile floor covering.
This will allow the range to be uloved fi)r cleaning or
servicing. Pdso, ulake sure vour floor covering will
withstand 180°E (See the Installation Safety Instructions
section.)
Make sure tile wall c(werings around your range can
withstand tile heat generated (up to 200°F) by tile range.
(See tile Installation Safety
Instructions
section.)
IMPORTANT!
Remove all tape mad packaghag. Make sure the burners
are properly seated mad level.
Take the accessory pack out of the oven mad/or drawer.
Check to be sure that no rmage parts have come loose
during shipphag.
36