GE JGBP35 Owner's Manual & Installation Instructions page 28

Care and cleaning of the range.
Burner Caps and Heads
NOTE: Before removing the burner caps
and heads, remember their sloe and location.
Replace them in the same location after
cleaning.
Usea sewing needleor twist-tie
to unclogflTesmallhole in the
burnerhead.
Burner caps
I Jfl off when cool. _\'ash burner caps
in hot, soapy water and rinse with clean
water: You me} scour with a I)lasfic scouring
pad to remoxe bm'ned-on fi)od particles.
Burner heads
For proper ignition, make sm'e the
small hole in the section that fits oxer the
electrode is kept open. A ,sewim,_needle
or wire twist-tie works well to tmclog it.
Thesilts in the burner heads must be kept clean
at aft times for an even, unhamperedflame.
Clogged or dim' burner po_Is or electrodes
_ill not allow the bm'ner to operate properly;
A W spill on or arotmd an electrode must
be carefifll) cleaned. Take care to not hit an
electrode with an){hing hard or it could
be damaged.
Y_)u should clean the burner caps and
bm'ner heads routinely, especially alter bad
spillove_s, which could clog the openings
in the bm'ner heads, i.ifl offwhen cool.
To remove bm'ned-on fl_od, soak the
bm'ner heads in a solution of mild liquid
detergent and hot water for 20-30 minutes.
For more stubboi]l stains, use a toothbrush.
After cleaning
gef_)re )uttino the burner ca )s and heads
back, sll,ake out excess water l,nd then dr,
them thoroughl_ b_ setting in a wam_ oxen
ti)r 30 ininutes.
NOTE: Do not use steel wool or scouringpowders
to dean the burners
Replacement
P, e place burner heads over the electrodes
on the cooktop, in the correct locations
according u) flmir size.
Meiiumhead
small I,gd
;;: Fro,,t of ran
Largehead Largehead
Make sm'e the slot in the bm'ner head is
positioned oxer the electrode.
Replace the matching size caps onto the
heads. There is one small, one medium
and two large caps.
Medium cap Small c ap
Largecap Largecap
Make sm'e that the heads and caps are
replaced in the correct locations,
28