Level The Range - GE JGBS04 Owner's Manual & Installation Instructions

Installation Instructions
[] LEVEL THE RANGE
[] Install the oven shelves in the oven and
position the range where it will be installed.
Raise
range
Lower
range
(on some models)
(on some models/
[] Check for levelness bu placing a spirit level
or a cup, partiallu filled with water, on one of
the oven shelves. If using a spirit level, take
two readings-with the level placed diagonallu
first in one direction and then the othen
[] Remove the broiler drawer or kick panel.
See the Care and cleaning of the range section.
The front leveling legs can be adjusted from
the bottom and the rear legs can be adjusted
from the top or the bottom.
[] Use an open-end or adjustable wrench to
adjust the leveling legs until the range is level.
[] After the range is level, slide the range awau
from the wall so that the Anti-Tip device can
be installed.
[] INSTALL THE ANTI-TIP DEVICE
WARNING -
• If the Anti-Tip Device supplied with the range
does not fit this application, use the Anti-Tip
Device WBO2klO020.
Range must be secured with an approved
Anti-Tip device.
Unless properlu installed, the range could be
tipped bu Uou or a child standing, sitting or
leaning on an open door.
After installing the Anti-Tip device, verifu that
it is in place bu carefullu attempting to tilt the
range forward.
This range has been designed to meet all
recognized industrg tip standards for all
normal conditions.
• The use of this device does not preclude
tipping of the range when not properlu
installed.
[]
Hark the wall where the RIGHT EDGE
of the range is to be located. Be sure
to allow for the countertop overhang
if Uou intend to install the range next
to cabinets.
Slotted head
Anti-Tip
device
I
I
1
Wallplate I
Approx. 20 I
Marked edge
21/8" of range
J
[] Locate the outside edge of the device 2Y8"
toward the center of the range from the
marked edge of the range.
[] Using the device as a template, mark the
position of the hole for the screw.
41