Table of Contents
Advertisement
Display assembly
Description
39.6-cm (15.6-in) High Definition (HD), LED BrightView display assembly:
For use in charcoal grey computer models
●
For use in Pacific blue computer models
●
For use in black computer models
●
LCD rubber kit
●
Display hinges
●
Display hinge covers
●
Before removing the display assembly, remove the following components:
1.
Battery (see
2.
Service door (see
3.
Optical drive (see
4.
WLAN module (see
5.
Keyboard (see
6.
Top cover (see
7.
USB board (see
Remove the display assembly:
1.
Turn the computer right-side up, with the front toward you.
2.
Open the computer as far as possible.
3.
Disconnect the display panel cable (1) from the system board and remove it from its routing
channel.
4.
Pull the antenna cables through the opening in the base enclosure (2), and then disengage the
cables from the clip in the routing channel leading to the display hinge.
CAUTION:
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
5.
Remove the five Phillips 6.0 x 2.5 screws (3) that secure the display assembly to the computer.
50
Chapter 4 Removal and replacement procedures
Battery on page
30)
Service door on page
Optical drive on page
WLAN module on page
Keyboard on page
39)
Top cover on page
41)
USB board on page
Support the display assembly when removing the display screws in the following
31)
34)
36)
47)
Spare part number
639512-001
701769-001
707798-001
640882-001
639511-001
640882-001
Advertisement
Table of Contents
