Remove the top cover:
1.
Remove the six Phillips PM2.5×6.5 screws (1) and the two Phillips PM2.5×10.0 screws (2) that
secure the top cover to the computer.
2.
Remove the four Phillips PM2.0×2.5 screws on the rear edge of the battery bay and in the hard
drive bay that secure the top cover to the computer.
3.
Remove the four Phillips PM2.5×4.0 screws on the front edge of the battery bay and near the hard
drive connector that secure the top cover to the computer.
56
Chapter 4 Removal and replacement procedures