GE JGB910 Owner's Manual page 51

[] Installing the Anti- lTp Device
WARNING:
• Range must be secured with an approved
Anti-Tip device.
• Unless properly installed, the range could be
tipped byyou or a child standing, sitting or
leaning on an open door.
• After installing the Anti-Tip device, verify that
it is in place by orefully attempting to tilt the
range forward.
IThis range has been designed to meet all
recognized industry tip standards for all
normal conditions.
• The use of this device does not preclude
tipping of the range when not properly
installed.
• If the Anti-Tip device supplied with the range
does notfit this application, use the univetsal
Anti-Tip device WB02X7909.
[] Mark the wallwhere the RIGHTEDGEof the
range is to be located. Be sure to allow for the
countertop overhang ffyou intend to install
the range next to cabinets.
1 11 w°"p l
//%_/
[] Locate the outside edge of the device 2_"
toward the center of the range from the
marked edge of the range.
[] Using the device as a template, mark the
position of the hole for the screw.
[] For wood construction, drill a pilot hole at an
angle of 90 degrees from the horizontal. A nail
or awl may be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you
wiUneed a 1/4" x 1½"lag bolt and a 1/2" O.D.
sleeve anchor, which are not provided. Drill
the recommended size hole for the hardware.
Wallboard
Anti-lip
device
• Wood screw
Back ofrange
Install the sleeve anchor into the drilled hole and
then install the lag bolt through the device. The
bolts must be properly tightened as recommended
for the hardware.
[] Slide the range agalust the wall, and check for
proper installation by grasping the front edge
of the cooktop and carefully attempting to tilt
the range forward.
When Aft Hookups Are Completed:
MAKESURE ALLCONTROLS ARELEFT IN THE OFF
POSTHOle.
MAKESURE THE FLOW OFCOMBUSTION A ND
VEN77LA?70N AIRTOTHE RANGE ISUNOBSTRUCTED.
Converting to LP Gas (or
conveFdng b acktonatural g asfrom LP)
This range leaves thePactoty s etforusewithnatural gas.
ff youwanttoconvert t oLP gas,theconversion mustbe
performed bya qualified LP gasinstaller.
The conversion instructions, sticker and LP orifices
can be found attached to the range next to the
pressure regulator.
There is a second set ofinstructious induded in the
envelope containing the product wiring diagrams
on the back of the range. Keep these instructions
and the orifices in case you want to convert back to
natural gas.
51