GE JGB910 Owner's Manual page 39

Wire coverholder,
Oven Shelves
Clean the shelves with an abrasive cleanser
or steel wool. After cleaning, rinse the
shelves with dean water and dry with a
dean cloth.
NOTE: Take t heshelves outoftheoven before y ou
begin theself.dean c_le.
OvenLightReplacement
CAUTION." Before r eplacing your o ven lightbulb,
disconnect theelectrical power t otherange atthe
main fuse orcircuitbreaker panel. Besuretolet_e
light c over andbulb cool completely.
The oven light bulb is covered with a
removable glass cover that is held in place
with a bail-shaped wire. Remove the oven
door, if desired, to reach cover easily.
Hold a hand under the cover so it
,t22
doesn't fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift off the cover.
Oo not _ve any _rews to remove
the cover,
[] Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
Toreplace
[] Place it into the groove of the light
receptacle. Pull the wire forward to the
center of the cover until it snaps into
place. When in place, the wire holds
the cover firmly. Be certain the wire is
in the depression in the center of the
cover.
[] Connect electrical power to the range.
Fluorescent TopLight
CAUTlON: Oonettouch thebulbwithwet hands or
whenthebulbisho_Never wipethelightarea with
a wetcloth.Electricalpower mustbeshutoff if you
havetoreplace thebulb.
[] Raise the clips on the back, on both
sides, and fi'ee the back of the canopy.
[] Roll the canopy up and off.
[] Remove the fluorescent light bulb.
Replace the bulb with one of the same
length and wattage.
[] Replace the canopy by placing the
front in the groove and rolling it back.
Snap it into place over the back clips on
both sides.
39