GE Profile JGB900 Owner's Manual And Installation Instructions page 55

www.GEAppliances.com
Possible Causes
Display goes blank A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is in the • See tile
Special features of your oven control
section.
black-out mode.
Display flashes
Power failure. * Reset tile clock.
Unable to get the Oven control pads were * Tile BAKE and BROILHI/LO pads must be touched :it
display to show "SF"
not pressed properly, tile same time mad held fm 3 seconds.
Power outage,
Power outage or surge. * Reset tile clock. If the oven was in use vet! nlust reset
clock flashes
it b)' touching the
CLEAR/OFFpad,
setting the clock
and resetting any cooking flmction.
"Burning" or "oily"
This is normal in a new oven * To speed tile pFocess, set a selfXcleau cycle foF a
odor emitting from
and will disappear in time. minimmn ot 3 hours. See the
Using the self-cleaning
the vent oven section.
Strong odor
An odor from the insulation * This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise (some models)
The convection fan may turn on • This is normal. The convection tim will mn until the
and off automatically, flmction is over or the door is ollened.
Convection fan not
Preheat temperature * Fan
will
start automatically once the preheat
working (some models)
not reached, teml)eratul'e is reached.
Drawer does not slide The drawer is out of afignment. * Fully extend the drawer and push it ;111the way in.
smoothlyor drags
See the Care and cleaning of the range section.
Drawer is over-loaded or load * Reduce weight. I_edistribute drawer contents.
is unbalanced.
Warming drawer will A fuse in your home may be * I_eplace the fl/se or reset the circuit breaker.
not work
blown or the circuit breaker
tripped.
The oven is self-cleanh_g. * Wait for the sell=(lean cycle to finish and the ()\'ell
to cool.
Controls improperly set. * See the Electric warming drawer section.
Excessivecondensation
Liquid in warming drawer. * geil/ove liquid.
in the warming drawer
Uncovered foods. • Cover tood with lid or aluminmn toil.
Temperature setting too high. * Reduce teml)erature settiu r
Food dries out in the Moisture escaping. • (_over fi)od with lid or almuinmn foil.
warming drawer
What To Do
• Replace the tuse or reset the circuit breakeL
55