Troubleshooting Tips - GE Profile JGB900 Owner's Manual And Installation Instructions

Before YouCall For Service...
Troubleshooting tips
Oven light does not work
Possible Causes
Light bulb is loose or defective.
Plug on rmage is not completely
hlserted in the electrical outlet.
What To Do
• Tighten or replace the bulb.
• Make sure electrical plug is plugged into a live, i)roperly
grounded outlet.
Oven willnotself-clean
The oven temperature is too
• _Mlow the
range to cool to room temperature
and
high to set a self-clema operation, reset the controls.
Oven controls improperly set. • See the
Usingthe self-cleaning
oven section.
"Crackling"
or This is the sound of the • This is normal.
"popping" sound
metal heating and cooling
during both the cooking mad
cleaning functions.
Excessive smoking
Excessive soil. • Touch the
CLEAR/OFF
land. Open the windows to
rid the room of smoke. _ait until the
LOCKEDDOOR
light goes off, _]l)e u l) the excess soil and reset the
clean cycle.
Oven door will not open
Oven too hot. • _dlow the oven to cool below locking tenq)erature.
after a clean cycle
Oven not clean after a Oven conlrols not properly set. • See the Using the self-cleaning oven secti()n.
clean
cycle
Oven was heavily soiled. • Clean up hen\ T Slfillovers before starting the clean
cycle. Heavily soiled ovens may need to sel6clean
again or fin" a h)nger l)eriod of time.
"LOCKDOOR"flashes
The self-clean cycle has been • (]lose the oven door,
in the display
selected but the door is not
closed.
LOCKED DOOR light
The oven door is locked
• Touch
the
CLEAR/OFF
land. Allow
the oven to cool.
is on when yon want because the temperature
to COOk inside the oven has not
dropped below the
locking temperature.
"T--and a number or You have a function error code. • Touch the CLEAR/OFF pad, Allow the oven to cool fi)r
letter" flash in the display one houi; Put the oven back into operation.
If the function code repeats. • Disconnect all l)ower to the range fin" 5 minutes
and then reconnect laower./f the traction error
code repeats, call for service.
Oven shelves are
The nickel shelves (if so equipped) • Apply
a small
amotmt of vegetable oil
to a paper
difficult to slide were cleaned ha a self-clema cycle, towel and wipe the edges of the oven shelves with
The gray porcelaha-coated shelves the l)aper towel. Do not spray with Pain '_or other
(if so equipped) were improperly lubricant sprays.
cleaned.
"Probe" appears in This is remhadhag
you to enter a
• Enter a probe
teml_erature.
the
display
(some models) probe temperature after plugging
ha the probe.
54