Burner Caps And Heads - GE Profile JGB900 Owner's Manual And Installation Instructions

www.GEAppliances.com
Burner Caps and Heads
NOTE: Before removing the burner caps
and heads, remember their size and location.
Replace them/n the same location after
cleaning The top sides of the Right Front,
Right Rear and Left Front burner heads are
marked with the letters "RF," "RR" and
"LE"
respectively, to aid reassembly,
Burner caps
I,ifl off when cool. Wash burner caps
in hot, soapy water and rinse with clean
water. You may scour with a plastic
scouring pad to remove burned-on
food particles.
Burner heads
The slits in the burner heads of your
cooktop must be kept clean at all times.
Clogged or dirty burner ports or
electrodes will not allow the burner to
operate properly.
Any spill on or around an electrode must
be carefully cleaned. Take care to not hit
an electrode with anything hard or it
could be damaged.
You should clean the burner caps,
burner heads and burner bases routinel>
especially after bad spillovers, which
could clog the openings in the burner
heads. I.ifl oH when cool.
To renlove burned-on food, soak the
burner heads in a solution of mild liquid
detergent and hot water for 20-30
II/iIltltes. [_or iiloi'e sttlbboril
stains,
use a toothbrush.
After cleaning
Before putting the burner caps and
heads back, shake out excess water and
then dry them thoroughly by setting in a
warm oven for 30 minutes.
NOTE." Do not use steel wool or scounbgpowders
to clean the burners or electrodes. Thiscan damage
the burners and electrically short the electrodes.
Replacement
The top sides of the Right Front, Right
Rear and Left Front burner heads are
marked with the letters "RF," "RR" and
"l.E" respectivel> to aid reassemblv.
Medium head
not FflarKerJ Srna [lead
alto cac and ca[
+,
{ :r0,t 0 fra,ge
Large i earl Extra _rge
and caE iread and
;ae
Replace the burner heads on the bases
matching the letters, ]).el)lace the caps on
the heads. Make sure that the caps and
heads are replaced in the correct
location, There is one small, one
IueditllH, ()lie large alld ()lie extra large
head and cap.
When replacing make sure the Iocator pflTs in the
burner head are seated in the pin slots of the burner
base. Rotate the burner head around the burner base
until it is level and securely seated.
33