HP 6930p - EliteBook - Core 2 Duo 2.8 GHz Maintenance And Service Manual page 83

5. Remove the heat sink (3) by sliding it up and forward.
NOTE: The thermal material must be thoroughly cleaned from the surfaces of the heat sink and
the system board each time the heat sink is removed. Thermal paste is used on the processor
(1) and the section of the heat sink (1) that services it. Thermal pads are used on the Northbridge
chip (2) and the section of the heat sink (2) that services it, and on the graphics subsystem chip
(3) and the section of the heat sink (3) that services it. Replacement thermal material is included
with all heat sink, system board, and processor spare part kits.
NOTE: Steps 6 through 8 apply only to computer models equipped with UMA graphics subsystem
memory. See steps 1 through 5 for removing the heat sink on computer models with discrete
graphics subsystem memory.
Component replacement procedures 73