Accessing HP ProtectTools Security
To access HP ProtectTools Security Manager:
1.
Click Start, click All Programs, and then click HP ProtectTools Security Manager for
Administrators.
– or–
Click Start, click Control Panel, and then click System and Security. Click HP ProtectTools
Security Manager.
NOTE:
nonadministrator mode to view information, but you cannot make changes.
2.
In the left pane, click HP ProtectTools, and then click Getting Started.
3.
Click the Security Manager Setup button, located directly below the HP ProtectTools shield icon,
to launch the Security Manager Wizard.
The following page is displayed:
4
Chapter 1 Introduction to security
If you are not an HP ProtectTools administrator, you can run HP ProtectTools in