4.
Remove the battery (see
5.
Remove the following:
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m. SIM connector board (see
When replacing the system board, be sure that the following components are removed from the defective
system board and installed on the replacement system board:
●
SIM (see
●
RTC battery (see
●
Memory modules (see
on page
●
WLAN module (see
●
WWAN module (see
●
Processor (see
●
Optical drive connector board (see
Remove the system board:
1.
Position the base enclosure with the rear panel toward you.
2.
Remove the two Phillips PM2.5×3.0 broad-head screws (1) that secure the system board bracket
to the base enclosure.
3.
Remove the two HM5.0×9.0 screw locks (2) that secure the system board bracket to the base
enclosure.
98
Chapter 4 Removal and replacement procedures
Battery on page
Hard drive (see
Hard drive on page
Optical drive (see
Optical drive on page
Keyboard (see
Keyboard on page
Switch cover (see
Switch cover on page
Fan (see
Fan on page
68)
Heat sink (see
Heat sink on page
Display assembly (see
Top cover (see
Top cover on page
ExpressCard board (see
Audio board (see
Audio board on page
Speaker (see
Speaker on page
Rear cover (see
Rear cover on page
SIM on page
48)
RTC battery on page
Primary memory module on page 64
57)
WLAN module on page
WWAN module on page
Processor on page
47).
53)
56)
61)
66)
69)
Display assembly on page
81)
ExpressCard board on page
85)
88)
92)
SIM connector board on page
55)
59)
65)
73)
Optical drive connector board on page
75)
84)
94)
and
Expansion memory module
101)