3.
Release the RJ-11 connector (4) from the clip built into the base enclosure.
4.
Remove the modem module cable.
Reverse this procedure to install the modem module cable.
Serial connector and cable
NOTE:
The serial connector and cable is included in the Cable Kit, spare part number 487138-001.
Before removing the serial connector and cable, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC Adapter from the computer.
4.
Remove the battery (see
5.
Remove the following:
a.
b.
c.
d.
e.
f.
g.
96
Chapter 4 Removal and replacement procedures
Battery on page
Hard drive (see
Hard drive on page
Optical drive (see
Optical drive on page
Keyboard (see
Keyboard on page
Switch cover (see
Switch cover on page
Display assembly (see
Top cover (see
Top cover on page
Rear cover (see
Rear cover on page
47).
53)
56)
61)
66)
Display assembly on page
81)
92)
75)