GE Monogram ZDP36L4DWSS Dimensions And Specifications

Monogram. ™
ZDP36L4DWSS—36" Professional Ranges
Dimensions and Specifications (in inches)
ZX22B36WSS
ZX12B36WSS
ZX1B36WSS
35-1/4"-36-3/4"
28-1/4"
Revised 7/97
21-1/4"
12"
1-1/2"
35-7/8"
These ranges are factory set for either natural gas or
liquid propane gas.
36" Natural Gas Model:
ZDP36N4DWSS–4 gas burners and griddle
36" Liquid Propane Gas Model:
ZDP36L4DWSS–4 gas burners and griddle
Accessory Requirements:
All models require the installation of a backguard. A
backguard should be ordered at the same time as the
range. Both must be on site at the time of installation.
Order one backguard for 36" models:
ZX1B36WSS–1-1/2" high backguard
(required for island installations)
ZX12B36WSS–12" high backguard
ZX22B36WSS–22" high backguard with warming rack
(2 piece)
Advance Planning:
Refer to dimensional drawings for appropriate placement
and necessary clearances when planning
the installation.
• Cabinetry cannot be installed directly above the range.
• This range requires the installation of a vent hood,
30" to 36" above the surface.
– The vent hood must be at least 24" deep.
– The vent hood must be the same width as the range.
– The vent hood must provide at least 600 CFM and
up to 800 CFM.
– When installing a range that includes a grill, select a
blower on the high end of the CFM recommendation.
• Working areas adjacent to the range should have
18" minimum clearance between countertop and
cabinet bottom.
• Clearance between range and side wall or combustible
material must be at least 12" on each side.
For answers to your GE Monogram,
GE, Hotpoint and RCA appliance questions, call
GE Answer Center service, 800.626.2000.
®
U L
Listed by
Underwriters
R
Laboratories
™ GE Profile, ™