Table of Contents
Advertisement
Optical drive connector cable
Description
Optical drive connector cable
Before removing the optical drive connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Memory module/wireless module compartment cover (see
b.
Keyboard (see
c.
Hard drive (see
d.
Top cover (see
Remove the optical drive connector cable:
1.
Disconnect the optical drive connector cable (1) from the system board.
2.
Release the optical drive connector cable from the clips (2) and routing channel built into
the base enclosure.
3.
Remove the two Phillips PM2.0×4.5 screws (3) that secure the optical drive connector to
the base enclosure.
56
Chapter 4 Removal and replacement procedures
Battery on page
35), and then remove the following components:
Keyboard on page
39)
Hard drive on page
45)
Top cover on page
49)
Spare part number
686257-001
Memory module on page
36)
Hide quick links:
Advertisement
Table of Contents
