GE JGB910 Owner's Manual & Installation Instructions page 55

www.GEAppliances.com
Possible Causes What To Do
Oven light does not work Light bulb is loose or defective. * Tighten or replace tile bulb.
Plug on range is not completely * Make sure electrical plug is plugged into a live, prol_erly
inserted ha the electrical outlet, grotmded outlet.
Oven will not self-clean The oven temperature is too * ?dlow the range to cool to room temperature and
high to set a self-dema operation, reset the controls.
Oven controls improperly set.
* See the Using the self-cleaning oven section.
"Crackling" or
This is the sound of the
* This is normal.
"popping" sound metal heating and cooling
during both the cooking mad
cleaning functions.
Excessive smoking Excessive soil. * Touch the CLEAR/OFF pad. Open the windows to
rid the room of smoke. X_ait until the LOCKED DOOR
light goes ott. Wipe up the excess soil and reset the
clean cycle.
Oven door will not open Oven too hot. • Allow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after a Oven controls not properly set. * See the Using the self-cleaning oven secti(m.
clean cycle Oven was heavily soiled. * Clean up heavv, spillovers befin'e ,startiw_ the clean
cycle. Heavily soiled ovens may need to sell=clean
again or for a longer period of time.
"tOCK DOOR" flashes The self-clean cycle has been * Close the oven door.
in the display
selected but the door is not
closed.
LOCKED DOOR light The oven door is locked * Touch the CLEAR/OFF l)ad. Allow the (),,'ell to cool.
is on when you want because the temperature
to COOk
inside the oven has not
dropped below the
locking temperature.
"F--anda number or You have a function error code. * Touch the CLEAR/OFF pad. ?dlow the oven to cool tbr
letter" flash in the display one hotm Put the oven back into ol)eratiou.
If the function code repeats. * Disconnect all power to the range fin" 5 minutes
and then reconnect power. If the flmctiou error
code )'el)eats , call fi)r service.
"Probe"appears in This is remhadhag
you to enter a
* Enter
a probe temperature.
the display probe temperature after plugging
in the probe.
55