GE JGB910 Owner's Manual & Installation Instructions page 41

Installation of the range.
Read these instructions completelF and carehdlg
BEFORE Y OU BEGIN
Installation of thb range must conform with local codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1,latest edition. In Canada, installation must conform with the current
Natural Gas Installation Code, CAN/CGA-B 149.1or the current Propane Installation Code, CAN/CGA-
B149.2, and with local codes where applicable. This range has been design-certified bythe American
GasAssociation according to ANSI Z21.1, latest edition and Canadian GasAssociation according to
CAN/CGA- 1.1latest edition.
As Mfl_ any appliance using gas and g_nerafing
heat, there are certain safety precautions you
should follow. You will find these precautions
in tile ImportantSafetylnformation sect.ion in the
flont of this manual. Read them ca_eflfllv.
IMPORTANT."Save these instructions for the local
electrical inspector's use.
NOTE TO INSTALLER:Leave these instructions
with the appliance after installation is completed.
NOTE TO CONSUMER:Keep this Owner's Manual
and Installation Instructions for future use.
NOTE,"This appfiance must be properly grounded.
FOR YOUR SAFETY
Oo not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity
of this or any other appliance.
ff you smell gas:
[] Open windows.
[] Don't touch elecuica] switches.
[] Extinguish any open flame.
[] Immediately call your gas supplier
ADDITIONAL MATERIALS YOUMAY NEED:
TOOLS YOU WILL NEED
Phillips and flat-blade screwdrivers
Pencil and ruler
:_Two pipe wrenches (one for backup)
Open-end or adjustable wrench
Nut drivers or wrenches: 3/16" and 1/4"
Gas line shut-offvalve
Pipe joint sealant or UL-approved pipe thread
tape with Teflon that resists action of natural
and LP gases
Flexible metal appliance connector (1/2" LD.)
A 5-footlength is recommended for ease of
installation but other lengths are acceptable.
Never use an old connector when installing a
new range.
*Teflon.RegisteredtrademarkofDuPont
Flare union adapter for connection to gas supply
line (3/4" or 1/2" NPTx 1/2" LD.)
Flare union adapter for connection to pressure
regulator on range (1/2" NPTx I/2" I.D.)
41