GE JGB910 Owner's Manual & Installation Instructions page 32

Care and cleaning of the range.
Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip device
is re-engaged properly when the range is replaced. Failure to take this precaution could
result in tipping of the range and cause injury.
Grate
Burnercap
Sealed Burner Assemblies--porcelain cooktop models
Turn all controls OFF betore removing the
burner parts and drip pans (if' so equipped).
The
btlFner gi'ates, caps, btlFner
heads and
drip pans (if so equipped) can be lifted off;
making them easy to clean.
CAUTION: Do not operate the burner without
The electrode of the spark igniter is
exposed when the burner head is
Drppa onsorernodes a//burner arts
p anddrippans(ifsoequ/))ped)
Burner head inp/ace.
removed. When one burner is tin'ned
to LITE, all the bm'ne_ spark. Do not
attempt to disassemble or clean
around any burner while another
bm'ner is on. An electric shock may
result, which could cause wm to
knock over hot cookware.
Use a sewing needle or twist-tie to
unclog the small hole in the burner
head.
After cleaning, make sure flTeslot
in the burner head is positioned
over flTeelectrode.
Burner Heads
NOTE" Beforeremoving the burner headsand
caps, rememberthe# size and location. Replace
them in the same location after cleaning.
For proper ignition, make sm'e the
small hole in the section that fits oxer the
electrode is kept open. A sewing needle or
wire twist-fie works well to tmclog it.
Theslits in the bumer heads of yourrange must be
kept dean at a// times for an even, unhampered
flame.
You should clean the surfi_ce bm'nets
routinely; especiall) after bad spilloxe_,
which could clog these openings.
To remove bm'ned-on fi_od, soak the
bm'ner heads in a solution of mild liquid
detergent and hot water tot 20-30 minutes.
For more stubborn stains, use a toothbrush.
Betin'e putting the bm'ner head back, shake
out excess water and then (li T it thoroughly
b)' setting it in a warn/ oven tin" 30 minutes.
Replace the bm'ner heads and caps. Make
sm'e that the heads and caps are replaced
in the correct location. There are 2 large,
one medium and one small head and cap.
Sma,
) Medium
Lagge
Burner Caps
I,ifl off when cool. X4_sh burner caps in
hot, soapy water and rinse with clean watex:
You may scour with a plastic scouting pad
to remove bm'ne(l-on food particles.
Dry them in a wam_ oven or with a cloth--
don't reassemble them wet. Replace the
burner caps.
Make sm'e that caps are replaced on the
correct size bm'ne_: There are 9 large, one
medium and one small head and cap.
32