GE JGB920 Owner's Manual And Installation Instructions page 55

Display goes blank A fuse in your home maybe
blown or the circuit
breaker tripped.
What To De
• Repla(e tile filse or reset tile (ir(uit 1)reaker.
The clock is in the • See tile Special features of your oven control section.
black-out mode.
Displayflashes Power failure. • Reset tile chwk.
Unable to get the Oven control pads were • Tile BAKE and BROIL HI/LO pads nmst be touched at
display to show "SF" not pressed properly, tile same time and held for 3 seconds.
Power outage, Power outage or surge. • Reset tile clock. If tile ()','ell WaS ill use, you must reset
clock flashes it by touching tile CLEAR/OFFpad, setting tile clock
and resetting any cooking time)ion.
"Burning" or "oily" This is normal in a new oven • To speed tile process, set a self'clean cycle
odor emitting from and will disappear in time. fi)r a mininmm of 3 hours. See tile Using the
the vent self-cleaning oven section.
Strong odor An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise The convection fan may turn on • This is normal. Tile convection thn will run until tile
and off automatically, tmlction is over or tile door is opened.
Convection fan Preheat temperature • Fan will sl_tI'[ automatically once tile preheat
not working
not reached, temperature is reached.
Drawer does not slide The drawer is out of alignment. • Fully extend tile drawer and push it all tile way in.
smoothly or drags See tile Care and cleaning of the range section.
Drawer is over-loaded or load • Reduce weight. Redistribute drmver contents.
is unbalanced.
Warming zone or A fuse in your home may be • Replace tile fnse or reset tile circuit breaker.
warming drawer blown or the circuit breaker
will not work tripped.
The oven is self-cleaning. • Wait for tile selfqlean cycle to finish and tile oven
to cool.
Controls improperly set. • See tile Using the electric glass top warming
zone se(tion.
• See tile Electric warming drawer section.
Excessive condensation Liquid in warming drawer. • Remove liquid.
in the warming drawer
Uncovered foods. • (;over food with lid or alunlinum foil.
Temperature setting too high. • Reduce temperature setting.
Food dries out in the Moisture escaping. • Cover food with lid or alunlinum tbil.
warming drawer
55