GE JGB920 Owner's Manual And Installation Instructions page 54

Before YouCall ForService (cont.)...
Troubleshooting -tips
Oven light does not work
What To Do
• Tighten or replace the bull).
• Make sure electrical plug is plugged into a live, properly
grounded outlet.
Oven willnot self-clean The oven temperature is too • Allow the range to cool to room temperature and
high to set a self-clean operation, reset the controls.
Oven controls improperly set. • See the Using the self-cleaning oven se('lion.
"Crackling" or This is the sound of the • This is normal.
"popping" sound metal heating and cooling
during both the cooking and
cleaning functions.
Excessive smoking Excessive soil. • Touch the CLEAR/OFF pad. Open the windows to
rid the room
of smoke.
Wait until
the LOCKED DOOR
light goes off. Wipe up the ex(ess soil and reset the
(lean cycle.
Oven door will not open Oven too hot. • Alh)w the oven to cool beh)w h)cking temperature.
after a clean cycle
Oven not clean after a Oven controls not properly set. • See the Using the self-cleaning oven se(ti_m.
clean cycle
Oven was heavily soiled. • Clean up hea_ T spillovers before starting the (lean
(Tcle. Heavily soiled ovens may need to self:clean
again or tbr a h)nger period of time.
"LOCK DOOR" flashes The self-clean cycle has been • (;lose the oven door.
in the display selected but the door is not
closed.
LOCKED DOOR light The oven door is locked • Touch the CLEAR/OFF pad. Alh)w the oven to cool.
is on when you want because the temperature
to cook inside the oven has not
dropped below the
locking temperature.
Possible Causes
Light bulb is loose or defective.
Plug on range is not completely
inserted in the electrical outlet.
"T--and a number or You have a function error code. • Touch the CLEAR/OFFpad. Allow the (wen to co(_l tbr
letter" flash in the display
one hour. Put the oven back into operation.
If the function code repeats. • Disconnect all power to the range for 5 minutes
and then reconnect power. If the flmction error
code repeats, call tbr service.
"Probe" appears in This is reminding you to enter a • Enter a probe temperature.
the display probe temperature after plugging
in the probe.
54