GE JGB920 Owner's Manual And Installation Instructions page 50

Insta#adonof therange(cont.).
[] Adjust Broil and Oven Burner Air Adjustment Shutters if Necessary
AI7adjustment shutters for thetopandbottomburners
regulate the flow of air to theflames. _}
S
Tile air a_[iustment shutter fi)r tile top (broil)
burner is in the center of the rear wall of the oven.
Tile shutter fi)r tile bottom (oven) burner is near
the back wall behind the winruing drawer. Remove
tlle drawer. See tl_e Care and cleaning of the range
section.
Toadjust the flow of a/7 to either burner,loosen the Phillips
head screw and rotate the shutter toward open or dosed
position as needed
The flatnes fo,"the top (broil) burner should be
steadywifll approximately 1"blue (ones and shouM
not extend out over the edges of tlle burner baffle.
To determine if tile bottom burner flmnes are
burning properly, rem{)ve the oven bottom. Flames
sh{mld have approximately 1" blue cones and, if
range is supplied with natural gas, shouM burn xdth
no yellow tipping. (With most I.P gas, small yellow
tips at the end of outer cones me normal.) Flmnes
sh{,uld ,lot lift off burner ports. If lifting is obsecved,
gra(hmlly re&me air shuuer opening until flmnes
me stabilized.
Toremovetheovenbottom:
[] Remove tile knurled screws hoMing dox_ll
rear of the oven bottom.
[] (;rasp tile oven bottom at finger slots on
each side.
[] Lift the rear of tim oven bottom enough to
clear tile lip of the range fiame, push it back,
and then pull it up and out.
50
[]
Levering the Range
[] Remove tile wa,ming drawer. See tile Careand
cleaningof the range section.
[] Use a 3/16" open-end or
s,xketwrendltoba(k
/" I 1 \
out both ,eat leveling {_._
)
legs app,,,Xil,l.ely 2
[ul'ns, _
[] Usea F!//' open-end or
a({justable x_Tench to _[_.._
back out the flont
leveling legs two
[Ul'nS,
[]
[]
Install the oven shelves in tile oven and
position file range where it _411 be installed.
Check ti)r levelness by placing a spirit level or a
cup, pmfially filled with water, on one of the
oven shelves. If using a spirit level, take/wo
readings-with the level placed diagonally first
in one direction and then the other.
[] A(!just tile leveling legs until the range is level.
[] After tlle range is lm,el, slide tlle range away
fiom tile wall so that tile Anti-Tip device
{an be installed.