Before You Begin; For Your Safety; Tools You Will Need - GE JGB920 Owner's Manual And Installation Instructions

Insta#aden of therange.
Read these instructions completely and carefufly,
BEFORE YOUBEGIN
Installation of this range must conform with local codes, or in the absence of local codes, with the
National Fuel Gas Code, ANSI Z223.1,latest edition. In Canada, installation must conform with the current
Natural Gas Installation Code, CAN/CGA-B 149.1or the current Propane Installation Code, CAN/CGA-
B 149.2,and with local codes where applicable. This range has been design-certified by the American
Gas Association according to ANSI Z21.1, latest edition and Canadian Gas Association according to
CAN/CGA- 1.1latest edition.
As with any appliance using gas and generating
heat, flle,e are certain saiety precautkms you
should fk)llow. You will find these precautions
in tile Important Safety Information section in the
fi_)nt of this manual. Read timm car_fully.
IMPORTAN_ Save these instructions for the local
electrical inspector's use.
NOTE TOINSTALLER:Leave these instructions
with the appliance after installation is completed.
NOTE TO CONSUMER:Keep this Owner's Manual
and Installation Instructions for future use.
NOTE." This applbnce must be properly grounded.
FOR YOUR SAFETY
Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity
of this or any other appliance.
ff yousmell gas:
[] Open windows.
[] Don't touch electrical switches.
[] Exdngafish any open flame.
[] Immediately call >)ur gas supplier.
40
TOOLS YOUWILLNEED
Phillips and flat-blade screwdrivers
Pencil and ruler
ADDITIONAL MATERIALS YOU MAY NEED:
Gas line shut-offvalve
Two pipe wrenches (one for backup)
3 "
1_ open-end or adjustable wrench
Nut drivers or wrenches: 3/16" and 1/4"
Pipe joint sealant or UL-approved pipe thread
tape with Teflon that rasists action of natural
and LP gases
Flexible metal appliance connector (1/2" LD.)
A 5-foot length b recommended for ease of
installation but other lengths are acceptable.
Never use an old connector when installing a
new range.
Flare union adapter for connection to gas supply
line (3/4" or 1/2" NPTx I/2" I.D.)
Flare union adapter for connection to pressure
regulator on range (1/2" NPTx 1/2" I.D.)
*Teflon. R egistered t rademark o f DuPont