GE JGB920 Owner's Manual And Installation Instructions page 32

Careendcleaningof therange.
Be sure electrical power is off and all surfaces are cool before cleaning any part of the range,
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip device
/s re-engaged properly when the range is replaced. Failure to take this precaution could
result in tipping of the range and cause injury.
3rate
Burner cab
Dnu uar oll solee rnooel
Burnerhead
_ CAUTION: Do not operate the
burner without all burner parts and
drip pans (if so equipped) in place.
Sealed Burner Assembfies--porcelain cooktop models
Turn all controls OFFbefine removing the
burner parts and drip pans (ifso equipped).
The burner grates, caps, burner heads and
drip pans (if so equipped) (an be lilied off,
making them easy to (lean.
'I\_E Iectr°de
The elecuode of the spa& igniter is
exposed when the burner head is
rem{)ved. When one burner is turned
to UTE,all the burners spark. Do not
attempt to disassemble or clean
mound any burner while another
burner is on. An elecuic shock may
result, which could cruise you m knock
over hot cookware.
Use a sewing needle or twist-tie to
unclog flTesmall hole in the burner
head.
After cleaning, make sure fire slot
in the burner head is positioned
over fire electrode.
Burner Heads
NOTE." Before remowbg theburnerheads and
caps,remember theksloeandlocation. R eplace
themtbthesamelocation afterclean/bg.
For proper ignition, make sure the
small hole in the section that fits over the
ele(uode is kept open. A sexdng needle or
wire twist-tie works well to unclog it.
Thesiltsin thebumerheadsof yourrawe mustbe
keptdeanat a// timesforan even,unhampered
flame.
You should clean the surlhce burners
routinely, especially after bad spillovers,
whi(h (ould (log these openings.
To remove burne&on fi)od, soak the
burner heads in a solution ofnfild liquid
detergent and hot water tbr 20-30 nfinutes.
For more stubborn stains, use a toothbrush.
Before putting the burner head back, shake
out excess water and then (hy it thoroughly
by setting it in a warln oven fi)r 30 inilmtes.
Replace the burner heads and caps. Make
sure that the heads and caps are replaced in
the conect location. There are 2 large, one
medium and one small head and cap.
Medium
Large
Burner Caps
I Jfl offwhen cool. Wash burner caps in
hot, soapywater and rinse with (lean water.
You may scour xdth a plastic scouring pad
to remove burned-on food particles.
DIT theln in a warm oven or xdth a cloth-
don't reassemble theln wet. Repla(e the
burner (aps.
Make suie that crapsare replaced on the
correct size burner. There are 2 large, one
medium and one small head and (ap.
32