GE JGB920 Owner's Manual And Installation Instructions page 21

Usingthe probe (on somemodels).
For many foods, especially roasts and poultry, internal food temperature is the best test for doneness. The
temperature probe takes the guesswork out of roasting by cooking foods to the exact doneness you want.
The temperature probe has a
skewer-like probe at one end and a
plug at the other end that goes flTto
the outlet f17 the oven.
Use of probes other than tile one
prmdded
_dtll this produ(t
may resuh in
(kunage to the probe.
Use tile handles of file probe and plug
when inserting and rem(Mng them fiom
tlle fi)od and outlet.
_,To avoiddamaging yourprobe,donot use
tongstopull on thecablewhenremowbg /t
To avoidbreaking theprobe, m akesurefood/s
completely d efrosted beforeinserting
Toprevent possible bums, do not unplug the
probe from the outlet until the ovenhas
coolecL
Plug
i _ Handles ![!!!
Never leaveyourprobeinsidetheovendunbg
a serf-cleaning c ycle.
Donot store the probe in the oven.
After preparing the meat and placing it
on a trivet or on the broiler pan grid,
tblh)w these directions fi)r proper probe
placement.
Insert tile probe completely into tlle
meat. It should not touch the bone,
fat or gristle.
For roasts x_ith no bone, insert the probe
into the meatiest part of the roast. For
bone-in ham or lamb, insert the probe
into the center of the lowest large muscle.
Insert the probe into the center of dishes
such as ineat loaf or casseroles.
Insert the probe into the meatiest part of
the inner flngh flom below and parallel
to tlle leg of a whole turkey.
! i/if@ (i
How to Set the Oven For Roasting When Using the Probe
[]
[]
Insert the probe into the food.
Plug tile probe into the outlet in tile
oven. Make sure it's pushed all the
way in. Close the oven door.
[]
Touch the PROBE pad.
[] Touch tile number pads to set tile
desired internal food or meat
temperature.
[] Touch tlle BAKE pad.
[] Touch the number pads to set the
desired oven temperature.
[]
Touch the STARTpad.
Thedisplay will flashif theprobeis inserted
into theoutletandyouhavenotset a probe
temperature a ndtouched theSTARTpad
After the internal temperature of the
toed reaches 100°F., the changing
internal temperature will be sh{)wn in
the (fisplay.
[] When the internal temperature of
the food rea(hes the number you
have set, the probe and the oven
mrn offand the oven control signals.
To stop the signal, touch the
CLFJIR/OFF pad. Use hot pads m
remove the probe fiom the toed.
Do not use tongs to pull on it-they
might dmnage it.
To change the (wen temperature during
the Roast _ycle, touch the BAKE pad and
then the mm_ber pads to set the new
temperature.
_, I f theprobe/sremoved from thefoodbefore
thefinal temperature i sreached, a tonewill
sound and thedisplay will flashuntiltheprobe
isremoved fromtheoven.
Youcan use the timer even though you
cannot use timed oven operations while
using the probe.
2/