Troubleshooting Tips - GE JB905 Owner's Manual

Beforeyoucall forservice...
_ Troubleshooting tips
Possible Causes What To De
Plug on range is not completely * Make sure electrical plug is plugged into a live, properly
in the electrical outlet, grounded oudet.
A fuse in your home * Replace the fuse or reset the circuit breaker.
may be blown or the
circuit breaker tripped.
Oven controls improperly sot. • See the Using the clock and timer secdon.
The oven temperature is • Allow the range to cool and reset the controls.
too high to set a self-clean
operation.
Oven controls improperly sot. * See the Usingtheself.cleaning oven section.
The probe is plugged into • Remove the probe from the oven.
the outlet in the oven.
(on some models)
This is the sound of the
metal heating and cooling
during both the cooking and
cleaning functions.
• This is normal.
Excessive soil. • Touch the C/.EAR/0FFpad. Open the windows to
rid the room of smoke. Wait until the LOCKEDlight
goes off. Wipe up the excess soil and reset the clean
cycle.
Oven too hot. • Allow the oven to cool below locking temperature.
Oven controls not properly set. * See the Osingthe self-cleaning oven section.
oven was heavily soiled. • Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
The self-clean cycle has been • Close the oven door.
selected but the door is not
dosed.
The oven door is locked • Touch the CLEAR/0FFpad. Allow the oven to cool.
because the temperature
inside the oven has not
dropped below the
locking temperature.
You have a function error code. • Touch the C_FF (oven) or ON/OFF (surface units)
pad. Try reactivating the conlxols.
If the function code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the function
error code repeats, call for service.
4O