Configuring Swipe Card Readers - Ricoh Aficio MP C2050 User Manual

PaperCut – Ricoh Embedded Manual
product ID. See the screenshot below showing the application information for the
PaperCut embedded application. The product id is a 9 digit number and is
highlighted below.

Take note of the application product id.
To configure the application switch buttons:

Login to the PaperCut admin site

On the "Devices" tab, select the Ricoh device to configure

Select the "Advanced Config" tab.

Locate the entry "ext-device.ricoh.app-button1.label". This is the text that appears
on the application button.

Change the button label to as appropriate, and press the "Update" button next to the
setting.

Locate the entry "ext-device.ricoh.app-button1.product-id". This will be set to
"DISABLED" to indicate the button is disabled.

Enter the product id of the application and press the "Update" button.

Confirm that the settings were saved. The settings will take effect after a short
period of time.
To create a second application switch button perform the same steps setting the "ext-
device.ricoh.app-button2.label" and "ext-device.ricoh.app-button2.product-id" settings.
To disable the application buttons set the product id settings to "DISABLED".

5.4 Configuring Swipe Card Readers

For a list of supported card readers please see Appendix A towards the end of this
document.
Swipe cards contain numbers which are used to identify users according to the card number
configured in the User Details screen under "Card/Identity" number. Some readers report
information in addition to the number encoded on the card, such as checksums. PaperCut
can treat these cases in two ways:
Copyright © 2012 PaperCut Software International Pty. Ltd., All Rights Reserved.
Revision: 19 2012-10-26
29 of 41