Page 1
dual electric mortar mixer 65760 Set up and operating inStructionS ® distributed exclusively by Harbor Freight tools 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our website at: http://www.harborfreight.com read this material before using this product. Failure to do so can result in serious injury. SaVe tHiS manual.
SaVe tHiS manual notice is used to address practices Keep this manual for the safety warn- not related to personal injury. ings and precautions, assembly, operat- caution, without ing, inspection, maintenance and cleaning the safety alert procedures. Write the product’s serial symbol, is used to address number in the back of the manual near the practices not related to...
Page 3
ranges and refrigerators. There is tached to a rotating part of the power an increased risk of electric shock if tool may result in personal injury. your body is grounded. do not overreach. Keep proper do not expose the mortar mixer to footing and balance at all times.
do not use an extension cord with tools are dangerous in the hands of this mortar mixer. untrained users. maintain the mortar mixer. check do not start the mortar mixer un- for misalignment or binding of til its left and right augers (28a, moving parts, breakage of parts 28B) are in the mixing drum.
grounded. The Ground Fault Cir- cannot be built into this product, but cuit Interrupter (GFCI) must also be must be supplied by the operator. implemented – it prevents sustained Vibration Safety electrical shock. Some dust created by power sand- This tool vibrates during use. Re- ing, sawing, grinding, drilling, peated or long-term exposure to and other construction activities,...
double insulated tools: tools Grip tool as lightly as possible (while still keeping safe control of it). Let with two prong plugs the tool do the work. To reduce vibration, maintain the tool as explained in this manual. If any abnormal vibration occurs, stop use immediately.
SpeciFicationS note: For additional information regarding the parts listed in the following pages, 110 V~ / 60 Hz / 8 Amps refer to the Assembly Diagram near Electrical Power Switch: Trigger with Safety Lock Requirements Power Cord: 16 AWG x 2C the end of this manual.
product FeatureS Place a mixing drum (not included) in the work area. Make sure the mixing drum is located on a flat, level ground upper surface. HouSing (16) Pour the material to be mixed (i.e., Speed regulator large batches of grout, concrete, or (17) SWitcH mortar) in the mixing drum.
grip throughout the mixing operation. must be performed only by a (See Figure B.) qualified technician. Press and hold the Switch Lock while to preVent pulling up on the Power Switch (1) SeriouS injurY to start the Mortar Mixer. The power From accidental switch must be held up all the time operation:...
If either Carbon Brush (9) is worn WARNING! If the Power Cord (6) of down by more than 1/2, replace this Mortar Mixer is damaged, it must both Carbon Brushes. be replaced only by a qualified ser- vice technician. To clean old Carbon Brushes (9) before reusing them, rub the contact pleaSe read tHe areas with a pencil eraser.
aSSemBlY diagram left auger (28a) and right auger (28B) not shown. 7/8” Wrench (28c) and 1-1/8” Wrench (28d) not shown. SKU 65760 For technical questions, please call 1-800-444-3353. Page 12...
Page 13
aSSemBlY diagram - continued SKU 65760 For technical questions, please call 1-800-444-3353. Page 13...
limited 90 daY WarrantY Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this prod- uct is free from defects in materials and workmanship for the period of 90 days from the date of purchase.