nOTICE is used to SAVE ThIS MAnuAL address practices not Keep this manual for the safety warnings related to personal injury. and precautions, assembly, operating, CAuTIOn, without the inspection, maintenance and cleaning safety alert symbol, is procedures. Write the product’s serial number used to address practices not in the back of the manual near the assembly related to personal injury.
Page 3
ranges and refrigerators. There is an up or carrying the tool. Carrying power tools with your finger on the increased risk of electric shock if your body is grounded. switch or energizing power tools that have the switch on invites accidents. Do not expose power tools to rain or wet conditions.
Page 4
with the switch is dangerous and must Screwdriver and Impact Wrench be repaired. Safety Warnings Disconnect the plug from the power hold power tools by insulated source and/or the battery pack from gripping surfaces when performing the power tool before making any an operation where the cutting tool adjustments, changing accessories, or storing power tools.
grounded. Ground Fault Circuit Vibration Safety Interrupter (GFCI) should also be This tool vibrates during use. Repeated implemented – it prevents sustained or long-term exposure to vibration may electrical shock. cause temporary or permanent physical WARNING: Some dust created by power injury, particularly to the hands, arms sanding, sawing, grinding, drilling, and and shoulders.
Page 6
SAVE ThESE away from the user, reducing the risk of electric shock. (See 3-prong plug and InSTRuCTIOnS. Outlet.) The grounding prong in the plug is gROunDIng connected through the green wire inside the cord to the grounding system in the TO pREVEnT tool.
Extension Cords RECOMMEnDED MInIMuM WIRE gAugE FOR EXTEnSIOn CORDS* (120/240 VOLT) Grounded tools require a three wire EXTEnSIOn CORD nAMEpLATE extension cord. Double Insulated LEngTh AMpERES tools can use either a two or three wire (at full load) 25’ 50’ 75’...
SpECIFICATIOnS ASSEMBLY InSTRuCTIOnS nOTE: For additional information regarding Electrical Input 120 V~ / 60 Hz / 4.2 A (Rated) the parts listed in the following pages, 2250 RPM (No Load) VSR Motor Speed refer to the Assembly Diagram near the Drive 1/4”...
Page 9
make sure the Trigger Lock mechanism To Change The Bit: is working properly. Always release the Trigger Lock mechanism before Pull forward on the Depth Collar (2) and remove it from the Clutch Housing (5). disconnecting the Drywall Screwdriver (See Figure A.) from its electrical outlet.
InSpECTIOn, MAInTEnAnCE, pLEASE READ ThE AnD CLEAnIng FOLLOWIng CAREFuLLY TO pREVEnT THE MANUFACTURER AND/OR SERIOuS InJuRY DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN FROM ACCIDEnTAL THIS MANUAL AS A REFERENCE TOOL OpERATIOn: ONLY. NEITHER THE MANUFACTURER unplug the power Cord (43) from its electrical outlet before OR DISTRIBUTOR MAKES ANY performing any inspection,...
pARTS LIST AnD DIAgRAM part Description part Description part Description Locator Spindle Brush Holder Lead Depth Collar Thrust Washer Gear Case Brush Bit Tip Holder Thrust Washer Trigger Trigger Lock Clutch Housing Pinion and Gear Shaft Seal Gasket Cord Clamp Spindle Gear Case Cover Screw (4.2 x 14)
Record product’s Serial number here: note: If product has no serial number, record month and year of purchase instead. note: Some parts are listed and shown for illustration purposes only, and are not available individually as replacement parts. To take advantage of this warranty, LIMITED 90 DAY WARRAnTY the product or part must be returned to us Harbor Freight Tools Co.