Main Inserts - Behringer EURODESK SX4882 User Manual

14
EURODESK SX4882 User Manual
Auxiliary returns
All six stereo pairs, to be located immediately below the aux sends,
are on unbalanced 1/4" jacks and operate at 0 dBu.
Fig. 7.3: Auxiliary returns
Subgroup inserts
Unbalanced send and return from a single stereo jack socket, wired tip = out,
ring = in and sleeve = ground/screen.
Fig. 7.4: Subgroup inserts
2-track in/out
RCA sockets for use with tape recorders, etc., signal = main mix, wired center
post = signal (+ve) and sleeve = ground/screen.
Fig. 7.5: 2-track in/out
2-track/external inputs
Two additional stereo inputs, this time on unbalanced 1/4" jacks,
wired tip = signal (+ve) and sleeve = ground/screen.
Fig. 7.6: Additional connectors
behringer.com

Main inserts

As above, but for the main mix.
Stereo outputs
The control room output (monitors) main mix, MIX-B and studio output are all on
a pair of unbalanced 1/4" jacks, nominal output level +4 dBu. The main mix is also
available as a fully balanced pair.
Phones 1/2
These are on stereo jacks, wired tip = left signal, ring = right signal and
sleeve = ground/screen (see section 6.4 "Headphones").
Meter/analyzer out
Unbalanced jacks at +4 dBu for use with external measuring equipment,
e.g. the built-in real-time analyzer of our BEHRINGER ULTRACURVE PRO DEQ2496
(signal = master LED meters).
Master balanced outputs
Balanced XLR for connecting to the mastering recorder. Wired pin 1 ground/
screen, pin 2 hot and pin 3 cold. Maximum level is +28 dBu.
Fig. 7.7: Main balanced outputs
Fig. 7.8: A and B-channel input section