Table of Contents
Advertisement
c.
Remove the four Phillips PM2.0×3.0 screws (1) that secure the display hinges to
the display panel.
d.
Remove the display hinges (2).
5.
To remove the wireless antenna cables and transceivers:
a.
Release the wireless antenna transceivers (1) from the display enclosure. (The wireless
antenna transceivers are attached to the display enclosure with double-sided tape.)
NOTE:
Some models may only have one antenna transceiver.
b.
Release the wireless antenna cables from the clips (2) built into the display enclosure.
c.
Remove the wireless antenna cables and transceivers (3).
6.
If replacing the display enclosure, be sure that the other subcomponents (including the webcam/
microphone module, the antenna receivers, and all associated cables and hardware) are
transferred to the new enclosure.
Reverse this procedure to reassemble and install the display assembly.
Component replacement procedures
77
Advertisement
Table of Contents
