Power connector
Description
Power connector (includes cable)
Before removing the power connector cable:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on
the computer, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the following components:
a.
Battery (see
b.
Hard drive (see
c.
WLAN module (see
d.
Keyboard (see
e.
Top cover (see
Remove the power connector cable:
1.
Position the computer upright, with the right side toward you.
2.
Disconnect the power connector cable (1) from the system board.
3.
Lift the power connector (2) from the clips built into the base enclosure.
Reverse this procedure to install the power connector.
58
Chapter 4 Removal and replacement procedures
Battery on page
36)
Hard drive on page
WLAN module on page
Keyboard on page
46)
Top cover on page
49)
37)
42)
Spare part number
602743-001